Arduino Portenta H7 - 32 bit ARM Microcontroller

The Arduino Portenta H7 is equipped with two processors that can perform parallel tasks. For example, this allows you to run Arduino on one core and MicroPython on the other and let them communicate with each other.
The board can be programmed with Arduino, MicroPython and TensorFlow™Lite, among others. Arduino runs on on the  Arm® Mbed™ OS on this board. 

Specifications:

• Supply voltage: 3.3V DC or 5V DC
• I/O voltage: 3.3V
• Power consumption (standby):  2.95 μA
• Chipset: STM32H747 dual core:
  • 480 MHz Cortex-M7 core
  • 240 MHz Cortex-M4 core
  • SRAM: 1MB
  • Flash memory: 2MB
• External SDRAM: 8MB
• External flash memory: 16MB
• Built-in WiFi
• Built-in Bluetooth
• Built-in ethernet interface (no built-in ethernet connector)
• Built-in camera interface
• NXP SE050C2 encryption chip
• External antenna with uFL connector
• USB-C interface:
  • USB Host functionality
  • DisplayPort out
  • Power delivery
• Display connector: MIPI DSI host and MIPI D-PHY
• GPU: Chrom-ART graphical hardware Accelerator™
• Timers: 22x timers and watchdogs
• UART: 4x Ports (2 with flow control)
• MKR Headers: Compatible with any industrial MKR shield
• High-density connectors: Two 80 pin connectors on the bottom of the board for all peripherals
• Camera Interface: 8 bit, up to 80MHz
• ADC: 3x ADC with max 16 bit (up to 36 channels)
• DAC: 2x 12 bit DAC (1MHz)
• PCB dimensions: 66 x 25mm

Package contents:

• 1x Arduino Portenta H7
• 1x Antenna

To program the Arduino Portenta H7 with the Arduino IDE, you first need to install the "Arduino mbed-enabled Boards" in the Board Manager.

For more information, see the following page: Arduino Portenta H7